2 – Using SANbox Manager | |
Starting SANbox Manager |
If the default fabric view file exists, the system prompts you to enter the file password as shown in Figure
Figure 2-2. Load Default Fabric View File Window
To start using the SANbox Manager application, do the following to add a fabric:
1.Open the Fabric menu and select Add Fabric to open the Add a New Fabric window as shown in Figure
Figure 2-3. Add a New Fabric Window
2.Enter a fabric name and the IP address of the switch through which to manage the fabric.
3.Enter an account name and a password. The factory account name is "admin" and the factory password is "password". If security is turned off (default), you are not required to enter an account name or password. This password is for the switch and is stored in the switch firmware. Refer to the User Command on page
4.Choose the Add Fabric button.