A – Command Line Interface | |
Set Config Command |
Set Config Command
Sets switch, port, and zoning configuration parameters.
Authority | Admin authority within a Config Edit session | |
Syntax | set config |
|
| port [port_number] |
|
| ports [port_number] |
|
| switch |
|
| zoning |
|
Keywords | port [port_number] |
|
| Changes configuration parameters for the port number given by [port_number]. If | |
| you omit this value, the system begins with port 0 and proceeds in order through | |
| port 15 or until you enter “qq”. The system displays each parameter one line at a | |
| time and prompts you for a value. For each parameter, enter a new value or press | |
| the Enter key to accept the current value shown in brackets. | |
| ports [port_number] |
|
| Very similar to the Set Config Port command, except that any attribute value that | |
| is changed by the user is applied to ALL ports. ONLY attribute values that are | |
| changed are updated; the attribute values that are not changed are left alone. | |
| Ports are numbered beginning with 0. The default is port 0. The system displays | |
| each parameter one line at a time and prompts you for a value. For each | |
| parameter, enter a new value or press the Enter key to accept the current value | |
| shown in brackets. Admin and config edit modes are required for this command. | |
| Table | |
|
|
|
| Parameter | Description |
|
|
|
| AdminState | Port administrative state: online, offline, |
|
| diagnostics, or down |
| LinkSpeed | 1Gb/sec or 2 Gb/sec |
| PortType | Type of port |
| TLPortMode | Initiates the configuration of ports |
|
| attributes. Indicates whether using |
|
| initiator or target devices on the loop. If |
|
| [port_number] is specified then the user |
|
| will be presented with attributes for that |
|
| port only; otherwise, all attributes for all |
|
| ports will be available for configuration. |
|
|
|
