Q-Logic 59022-03 D manual Table A-7. Set Config Switch Parameters

A – Command Line Interface	￿
Set Config Command

switch

Initiates an editing session in which to change switch configuration settings. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

Table A-7. Set Config Switch Parameters

Parameter	Description
AdminState	Switch administrative state: online,
	offline, or diagnostics.
Broadcast Enable	Enables or disables (default) forwarding
	if broadcasting frames.
DefaultDomainID	Default domain ID setting
DomainIDLock	If set to True (default), prevents domain
	ID from being changed.
SymbolicName	Descriptive name
R_T_TOV	Receiver Transmitter Timeout Value.
	Specifies the number of milliseconds a
	port is to wait to receive a response
	from another port. The default is 100.
R_A_TOV	Resource Allocation Timeout Value.
	The number of milliseconds the switch
	waits to allow two ports to allocate
	enough resources to establish a link.
	The default is 10000.
E_D_TOV	Error Detect Timeout Value. The
	number of milliseconds a port is to wait
	for errors to clear. The default is 2000
	msec.
FS_TOV	Fabric Stability Timeout Value. The
	default is 5000 msec.
DS_TOV	Distributed Services Timeout Value
	(Management Server, Name Server).
	The default is 5000 msec.
PrincipalPriority	The priority used in the FC-SW-2
	principal switch selection algorithm. 1 is
	high, 255 is low.
Description	The name for the configuration. The
	default is undefined.

A-26 59022-03 D