Q-Logic IB0056101-00 G manual Cabling and Switches, 2. QLogic InfiniBand Cables, Product Number

A

4 – Hardware Installation Hardware Installation Requirements

Cabling and Switches

The cable installation uses a standard InfiniBand (IB) 4X cable. Any InfiniBand cable that has been qualified by the vendor should work. For SDR, the longest passive copper IB cable that QLogic has currently qualified is 20 meters. For DDR-capable adapters and switches, the DDR-capable passive copper cables cannot be longer than 10 meters. Active cables can eliminate some of the cable length restrictions.

InfiniBand switches are available through QLogic.

NOTE:

If you are using the QLE7240 or QLE7280 and want to use DDR mode, then DDR-capable switches must be used.

The copper cables listed in Table 4-2are available from QLogic:

Table 4-2. QLogic InfiniBand Cables

Product Number	Description
7104-1M-Cable	4x-4x cable—1 meter
7104-2M-Cable	4x-4x cable—2 meters
7104-3M-Cable	4x-4x cable—3 meters
7104-4M-Cable	4x-4x cable—4 meters
7104-5M-Cable	4x-4x cable—5 meters
7104-6M-Cable	4x-4x cable—6 meters
7104-7M-Cable	4x-4x cable—7 meters
7104-8M-Cable	4x-4x cable—8 meters
7104-9M-Cable	4x-4x Cable—9 meters
7104-10M-Cable	4x-4x cable—10 meters
7104-12M-Cable	4x-4x cable—12 meters (SDR only)
7104-14M-Cable	4x-4x cable—14 meters (SDR only)
7104-16M-Cable	4x-4x cable—16 meters (SDR only)
7104-18M-Cable	4x-4x cable—18 meters (SDR only)

For cabling instructions, see “Cabling the Adapter to the InfiniBand Switch” on page 4-17.

IB0056101-00 G 4-3