Quick Start Guide RIC-E1 Installation and Operation Manual
2 Operating RIC-E1
Jumper Description Values Default Setting
JP2, JP3 Select the E1 interface type BALANCE – Balanced interface
(RJ-45 connector)
UNBALANCE – Unbalanced
interface (BNC
coax connectors)
BALANCE
ALB DTE, JP4 Enables local analog
loopback activation from
the DTE (via pin 18 for
RS-530 or via pin “JJ” for
V.35)
EN – The local analog loopback
activation from the DTE is
enabled
DIS – The local analog loopback
activation from the DTE is
disabled
DIS
Note: The JP4 jumper is not available for RIC-E1/R cards with X.21 or Ethernet interfaces.
PNL SW, JP5 Enables activation of the
local analog loopback via
the front panel pushbutton
EN – The LLB can be activated via
the front panel
DIS – The LLB cannot be
activated via the front
panel
EN
Note: The JP5 jumper is not available for RIC-E1/R cards with IR-ETH and IR-ETH/V interface modules.
For RIC-E1/R with IR-IP interface module, the JP5 jumper serves for enabling or disabling the IP LEARN
pushbutton.
TX&RX CODE, JP6 Selects the data receive
and transmit coding
HDB3
AMI
HDB3
TIMING SEL, J2 Selects the clock reference RCV – Receive clock
EXT – External clock
INT – Internal clock
RCV
Note: Units with the IR-ETH, IR-ETH/V and IR-IP interface modules support only receive and internal clocks.
CHASS GND, J3 Controls the connection
between the RIC-E1/R
signal ground and the
frame (chassis) ground
CON – Signal ground is
connected to the frame
ground
DISCON – Signal ground is
disconnected from the
frame ground
CON

Connecting the Cables

To connect cables:

1. Connect the E1 line interface.

2. Connect the DTE interface.

3. Connect the power cable (first to the converter, then to the mains supply).

The PWR LED lights when power is connected.

2. Operating RIC-E1

RIC-E1 operates entirely unattended except when performing system tests.

Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com