RAD Data comm RIC-E1 operation manual Management Access Menu, Protocol, Telnet Password

Models: RIC-E1

1 99
Download 99 pages 62.9 Kb
Page 72
Image 72

Appendix D IR-IP Interface Module

RIC-E1Installation and Operation Manual

 

 

Protocol

Used to select the WAN protocol to be used by the IP router card: PPP, HDLC or Frame Relay.

This parameter is available only if the Read Protocol from DIP Switches parameter is set to NO.

D.8 Management Access Menu

The Management Access menu is used to enable the use of passwords to protect the access to IR-IP management utility, and control the inactivity time-out interval.

When password protection is enabled, a Telnet management session can start only after the correct password is entered.

To access the Management Access menu:

From the Main menu, type 2.

The Management Access menu appears (Figure D-11).

IR_IP<IR-IP>S/W Ver. 1.21 31/IR (date)

Quick Setup Management Access

=====================================================================

1.

Telnet Password

:

2.

Telnet Inactivity Timeout (min)

:300..

3.

SNMP Access

:Disabled

4.

SNMP Read Community

:public....

5.

SNMP Write Community

:public....

6.

SNMP Trap Community

:public....

7.

SNMP Management Table

:>>>

Press one of the numbers to select or ESC:

Figure D-11. Management Access Menu

Note Since the IP router card does not support SNMP management, the SNMP Read Community, SNMP Write Community, SNMP Trap Community, and SNMP Management Table parameters are not used.

Telnet Password

By default, management access to IR-IP via Telnet is unrestricted. To restrict access, enter a Telnet password by selecting 1 in the Management Access menu. The password can include up to 10 characters, and is case-sensitive. The next time a Telnet session is opened, a password must be entered to enable you to access the IR-IP menus.

At any time, only one Telnet connection to IR-IP is permitted. Any attempt to open an additional connection while the current session is open is rejected.

D-16 Management Access Menu

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610

www.bestdatasource.com

Page 72
Image 72
RAD Data comm RIC-E1 Management Access Menu, Protocol, Telnet Password, To access the Management Access menu