RAD Data comm operation manual RIC-E1 Jumper Locations RIC-E1 Jumper Settings

RIC-E1Installation and Operation Manual Chapter 2 Installation and Setup

JP1 JP2 JP3 JP4

BAL

BNC

BAL	JP6
BNC
RCV	J4
EXT
INT
TX & RX CODE
AMI	JP9
HDB3

LOC	JP11
	DTE

ANA LOOP

	Figure 2-1. RIC-E1 Jumper Locations
	Table 2-1.	RIC-E1 Jumper Settings
Jumper	Description	Values	Default Setting
JP1, JP2, JP3, JP4,	Select the E1 interface type	BAL – Balanced interface	BAL
JP6		(RJ-45 connector)
		BNC – Unbalanced interface (BNC
		coax connectors)
TX & RX CODE,	Selects the transmit and	AMI – Jumper plug is installed
JP9	receive coding	HDB3 – Jumper plug is not installed	HDB3
TIMING, J4	Selects the clock reference	RCV (pin 4) – Receive clock	RCV
		EXT (pin 5) – External clock
		INT (pin 6) – Internal clock

Note: Units with the IR-ETH, IR-ETH/Vand IR-IP interface modules support only receive and internal clocks.

ANA LOOP, JP11 Controls the local analog	LOC – Activates the local analog
loopback activation	loopback
	DTE – Allows the activation of the	DTE
	local analog loopback via DTE

Configuring RIC-E1 2-3

Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com