Appendix D IR-IP Interface Module RIC-E1 Installation and Operation Manual
D-6 IR-IP Managem ent Subsystem, General
Table D-3. IR-IP Controls
Control
RIC-E1 RIC-E1/R
Function Values Default
Setting
DIP switch,
section 1
IP LEARN
pushbutton,
DIP switch,
section 5
Enables IR-IP to learn its IP ON – IP address learning is enabled
OFF – IP address learning is disabled
OFF
Note: IP LEARN pushbutton settings override settings of the DIP switch.
DIP switch,
section 2
DIP switch,
section 4
Selects the WAN protocol ON – PPP protocol
OFF – Frame Relay protocol
OFF
DIP switch,
section 3
DIP switch,
section 3
Selects the LAN mode ON – Full duplex operation
OFF – Half duplex operation
OFF
DIP switch,
section 4
DIP switch,
section 2
Controls the remote WAN test
loopback, which returns
packets received from the
WAN back toward the WAN
ON – The test loopback is activated
OFF – The test loopback is disabled
OFF
– DIP switch,
section 6
Allows the user to operate the
module in case the IP address
and/or Telnet password are lost
ON – Forces default IP password
and/or no password protection
OFF – IR-IP operates according to
user configuration
OFF
– DIP switch,
section 1
Not in use – –
When using the IP LEARN pushbutton for the IP address configuration, make sure
that the PNL SW jumper (JP5) on the RIC-E1/R PCB is set to EN.
Table D-4 provides the pinout of the IR-IP RJ-45 connector.
Table D-4. RJ-45 Pinout
Pin Name Function
1 TD (+) Transmit data positive
2 TD (-) Transmit data negative
3 RD (+) Receive data positive
6 RD (-) Receive data negative
D.4 IR-IP Management Subsystem, General The IR-IP interface module management subsystem supports the following
functions:
• Preliminary configuration
• Configuration of management access parameters
• Advanced configuration of IR-IP parameters
• Collection and display of statistical performance data
• Maintenance functions, which include:
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com