| P100IH ISDN Router | ||
|
|
|
|
IP Address Supplied By: |
|
|
|
|
|
|
|
If set to Yes, the Prestige will allow a remote host to | (Default = Yes) |
| |
| specify its own IP address. | Yes/No |
|
| If set to No, the remote host must use the IP address |
| |
|
|
| |
| assigned by your Prestige from the IP pool, configured |
|
|
| below. This is to prevent the remote host from using an |
|
|
| invalid IP address and potentially disrupting the whole |
|
|
| network. |
|
|
|
|
|
|
IP Pool | This field tells your Prestige to provide the remote host | Yes/No |
|
| with an IP address from the pool. This field is required if | (Default = No) |
|
|
|
| |
| No. You can configure this field even if |
|
|
| to Yes, in which case your Prestige will accept the IP |
|
|
| address if the remote peer specifies one; otherwise, an |
|
|
| IP address is assigned from the pool. |
|
|
|
|
|
|
IP Pool: IP Start Addr | This field is applicable only if you selected Yes in the |
|
|
|
|
| |
| The IP pool contains contiguous IP addresses and this |
|
|
| field specifies the first one in the pool. |
|
|
|
|
|
|
IP Count (1,2) | In this field, enter the number (1 or 2,) of addresses in | 1, 2 |
|
| the IP Pool. For example, if the starting address is |
|
|
| 192.168.135.5 and the count is 2, then the pool will have |
|
|
| 192.68.135.5 and 192.68.135.6 |
|
|
|
|
|
|
Session Options: | Press Yes, then [Enter] to edit the filter sets. Keep in | Default = No |
|
Edit Filter Sets | mind that the filter set(s) will only apply to remote |
|
|
users but not the remote nodes. |
|
| |
|
|
| |
| Note that spaces and |
|
|
| field. For more information on customizing your filter |
|
|
| sets, see Chapter 8 - Filter Configuration. The default is |
|
|
| blank, i.e., no filters. |
|
|
|
|
|
|
Once you have completed filling in Menu 13 - Default |
| ||
ENTER to Confirm…] to save your configuration, or press [Esc] at any time to cancel. |
|
| |
|
|
|
|
7.2.2Default Dial-in Filter
Use Menu 13.1 – Default
|
