P100IH ISDN Router

 

 

Table 6-2 TCP/IP Remote Node Configuration

 

 

 

 

 

 

 

 

Rem IP Address

This will show the IP address you entered for this remote node

 

 

 

 

in the previous menu.

 

 

 

 

 

 

 

 

Rem IP Subnet

Enter the subnet mask for the remote network.

 

 

 

Mask

 

 

 

 

 

 

 

 

 

My WAN Addr

Some implementations, especially the UNIX derivatives, require the

 

 

 

 

WAN link to have a separate IP network number from the LAN and

 

 

 

 

each end must have a unique address within the WAN network

 

 

 

 

number. If this is the case, enter the IP address assigned to the WAN

 

 

 

 

port of your Prestige.

 

 

 

 

Note that this is the address assigned to your local Prestige

 

 

 

 

WAN, not the remote router. If the remote router is a Prestige,

 

 

 

 

then this entry determines the local Prestige Rem IP Address

 

 

 

 

in menu 11.1 (see Table 6-1).

 

 

 

 

 

 

 

 

NAT

Choose from None, Full Feature or SUA Only. See Chapter 4:

 

 

 

 

for a full discussion of this new feature.

 

 

 

Address Mapping

A NAT Server Set is a list of LAN side servers mapped to

 

 

 

Set=

external ports (similar to the old SUA menu 15.1 before). You

 

 

 

 

may enter any server set number up to 10, but the first one is

 

 

 

 

used foe SUA only.

 

 

 

 

 

 

 

 

Metric

The metric represents the “cost” of transmission for routing

1 to 15

 

 

purposes. IP routing uses hop count as the measurement of

 

 

 

 

cost, with a minimum of 1 for directly connected networks.

 

 

 

 

Enter a number that approximates the cost for this link. The

 

 

 

 

number need not be precise, but it must be between 1 and 15.

 

 

 

 

In practice, 2 or 3 is usually a good number.

 

 

 

 

 

 

 

Private

This parameter determines if the Prestige will include the route

Yes/No

 

 

to this remote node in its RIP broadcasts. If set to Yes, this

 

 

 

 

route is kept private and not included in RIP broadcast. If No,

 

 

 

 

the route to this remote node will be propagated to other hosts

 

 

 

 

through RIP broadcasts.

 

 

 

 

 

 

 

 

RIP

Press the space bar to select the RIP direction from Both/In

 

 

 

 

Only/Out Only.

(Default=Both)

 

 

 

 

 

 

 

 

Version=

Press the space bar to select the RIP version from RIP-1/RIP-

RIP-1

 

 

2B/RIP-2M.

(default)

 

 

 

 

 

6-4

Remote Node TCP/IP Configuration

Page 84
Image 84
ZyXEL Communications 1001H manual TCP/IP Remote Node Configuration, Only/Out Only