ZyXEL Communications 1001H manual Default Dial-in Setup Fields, Required

P100IH ISDN Router

Menu 13 - Default Dial-in Setup

Telco Options:	IP Address Supplied By:
CLID Authen= None	Dial-in User= Yes
	IP Pool= No
PPP Options:	IP Start Addr= N/A
Recv Authen= CHAP/PAP	IP Count(1,2)= N/A
Compression= Yes
Mutual Authen= No
O/G Login= p100ih
O/G Password= ********
Multiple Link Options:
Max Trans Rate= 128
	Session Options:
Callback Budget Management:	Edit Filter Sets= No
Allocated Budget(min)=
Period(hr)=

Press ENTER to CONFIRM or ESC to CANCEL:

Press Space Bar to Toggle.

Figure 7-3 Menu 13 – Default Dial-in Setup

From the Main Menu, enter 13 to go to Menu 13 – Default Dial-in Setup. This section describes how to configure the protocol-independent fields in this menu. For the protocol-dependent fields, refer to the appropriate chapters.

The table below describes and contains information on how to configure each parameter in Menu 13 – Default Dial-in Setup.

Table 7-2 Default Dial-in Setup Fields

Field	Description		Options
Telco Options: CLID	This field sets the CLID authentication parameter for all
Authen	incoming calls. There are three options for this field:		None
	z	None - No CLID is required.
	z	Required – CLID must be available, or the Prestige	Required
		will not answer the call.	Preferred
	z	Preferred - If the CLID is available then CLID will
		be used; otherwise, authentication is performed in
		PPP negotiation.
PPP Options:

7-4 Dial-In Server Configuration