P100IH ISDN Router
Once you have completed filling in the Network Layer Options Menu, press [Enter] to return to Menu
11.Press [Enter] at the message [Press ENTER to Confirm...] to save your configuration, or press [Esc] at any time to cancel.
6.1.2Static Route Setup
Static routes tell the Prestige routing information that it cannot learn automatically through other means. This can arise in cases where RIP is disabled on the LAN or a remote network is beyond the one that is directly connected to a remote node.
Each remote node specifies only the network to which the gateway is directly connected, and the Prestige has no knowledge of the networks beyond. For instance, the Prestige knows about network N2 in the following diagram through remote node Router 1. However, the Prestige is unable to route a packet to network N3 because it doesn’t know that there is a route through remote node Router 2. The static routes are for you to tell the Prestige about the networks beyond the remote nodes.
Figure 6-4 Example of Static Routing Topology
To configure an IP static route, use Menu 12, Static Route Setup, as displayed below.
From Menu 12, select one of the available IP static routes to open Menu 12.1 - IP Static Route Setup, as shown below.
Remote Node TCP/IP Configuration |
