P100IH ISDN Router

Chapter 10:

Telnet Configuration and Capabilities

10.1 About Telnet Configuration

Before the Prestige is properly setup for TCP/IP, the only option for configuring it is through the console port. Once your Prestige is configured, you can use telnet to configure it remotely as shown below.

Figure 10-1 Telnet Configuration on a TCP/IP Network

10.2 Telnet Under NAT

When NAT is enabled and an inside telnet server is specified, telnet connections from the outside will be forwarded to the inside server. So to configure the Prestige via telnet from the outside, you must first telnet to the inside server, and then telnet from the server to the Prestige using its inside LAN IP address. If no insider server is specified, telnet to the SUA ’s IP address will connect to the Prestige directly.

Telnet

10-1

Page 121
Image 121
ZyXEL Communications 1001H manual Telnet Configuration and Capabilities, About Telnet Configuration, Telnet Under NAT