ZyXEL Communications 1001H manual Enable, Disable, Yes then

				P100IH ISDN Router
	Incoming:	Callback	This field is applicable only if Call Direction is Both.		Enable
			Otherwise, a N/A appears in the field.		Disable
			This field determines whether or not your Prestige will call
			back after receiving a call from this remote node.
			If this option is enabled, your Prestige will disconnect the
			initial call from this node and call it back at the Outgoing
			Primary Phone Number (see below).
	Outgoing:	My Login	This is a required field [?] if Call Direction is either Both
		Name	or Outgoing. Enter the login name for your Prestige when
			it calls this remote node.
	Outgoing:	My	This is a required field [?] if Call Direction is either Both
		Password	or Outgoing. Enter the password for your Prestige when
			it calls this remote node.
	Outgoing:	Authen	This field sets the authentication protocol used for
			outgoing calls.
			Options for this field are:
			z CHAP/PAP - Your Prestige will accept either CHAP		CHAP/PAP
				or PAP when requested by this remote node.
			z	CHAP - accept CHAP only.	CHAP
			z	PAP - accept PAP only.	PAP
	Outgoing:	Pri(mary)	Your Prestige always calls this remote node using the
		Sec(ondary)	Primary Phone number first for a dial-up line.
		Phone	If the Primary Phone number is busy or does not answer,
		Numbers
			your Prestige will dial the Secondary Phone number if
			available.
			Some areas require dialing the pound sign # before the
			phone number for local calls. A # symbol may be included
			at the beginning of the phone numbers as required.
	Edit PPP Options		To edit the PPP options for this remote node, move the		Press
			cursor to this field, use the space bar to select Yes and		space bar
			press [Enter]. This will bring you to Menu 11.2 - Remote		to toggle
			Node PPP Options. For more information on configuring		Yes then
			PPP options, see the section Editing PPP Options.		press
					[Enter]
	Rem IP Addr		This is a required field [?] if Route is set to IP. Enter the
			IP address of the remote gateway.
5-4				Remote Node Configuration