Paradise P300 specifications Configuration Summary, Carr Disabled, Carr Fault

CONFIGURATION SUMMARY

Tx:70.0000MHz 2048k Rx:70.0000MHz 2048k

CARR:Normal Eb/No>15.0dB LOCAL Info

Configuration Summary Screen 9

This screen displays a summary of the configuration on the top line. The lower line provides carrier unit and traffic messages such as "Carr:On", "Unit Fault" or "Traffic Warn", and the operator has to press the Down key to display the Tx & Rx Traffic Summary screen in order to determine what the fault is. The fields can take the following values:

Carrier Status:	CARR: Normal	Normal Tx status
	CARR: DISABLED	Carrier state set to `Off` (formerly CARR:Mute-Off)
	CARR: Mute-Brk	Carrier set to `Power Break Mute`, requires
		operator to confirm if carrier can be
		retransmitted as power outage has occurred.
	CARR: Mute-1:1	Muted by 1 for 1 logic
	CARR: Mute-Ext	Muted by external signal on alarms connector
	CARR: Mute-RTS	Carrier set to RTS controlled, and interface RTS
		line is off
	CARR: Mute-Flt	Muted, due to an internal fault (eg synthesiser lock)
	CARR: FAULT !!	There is a fault in the carrier on/off logic,
		disconnect the carrier from the satellite.

Demod status:	Not Locked
	Eb/No=xx.xdB

Pressing the down arrow leads to further9information

Unit Status (in order of priority):

Unit Fault

Cfg-Error

Unit-Warn

Cfg-Warn

Cfg-Info

Traf-Fault

Traf-Warn

Remote

Local

If the demodulator is unlocked

When the demodulator is locked a valid Eb/No is displayed

There is a Unit Fault

The Unit cannot perform as requested There is a Unit Warning

There is a configuration warning (from Setup, Check)

There is a Config Info message (from Setup, Check)

A Traffic Fault exists

A Traffic Warning exists

Remote M&C mode, no warnings or test modes active.

Local mode, no warnings or test modes active.

P300H P300 Series Modem Installation and Operating Handbook Page 50