Paradise P300 specifications Change, Tx/Rx, ESC/Aux/BA, Config Async, Baud Rate Menu

6.6.30 Change, Tx/Rx, ESC/Aux/BA, Config Async, BAUD RATE Menu

ESC Baud rate: [2400] (YES) (Max continuous rate 89is 2962)

Change, Tx/Rx, ESC/Aux/BA, Cfg. Async, Baud Rate Menu

This menu allows the Baud rate for the external interface to the ESC channel to be set. Any rate can be set, although the maximum continuous rate supported is stated (calculated from the terrestrial rate, and async character format).

Refer to section 8.6 "Determining exact maximum ESC Baud rates" on page 146

6.6.31 Change, Tx/Rx, ESC/Aux/BA, Config Async, FORMAT Menu

Async Format: [7 bits, No parity]

1=7 bits, 2=8 bits, Parity: 3=None, 4=Even, 5=Odd (Yes)

Change, Tx/Rx, ESC/Aux/BA, Cfg. Async, Format Menu

The ESC async character format may be edited by pressing 1 or 2 to select 7 or 8 bits, and 3, 4, or 5 to select No parity, Even parity, or Odd parity respectively. Note that as described in the last paragraphs shortening the async character reduces the maximum continuous Baud rate, as the ESC channel is limited to a finite character rate per second, and the more bits in each async character, the higher the effective Baud rate allowed without exceeding the ESC channel character rate limit.

6.6.32Change, Tx/Rx, ESC/Aux/BA, Config Async, SET AS REM M&C

This option sets the ESC channel async parameters to match the settings on the Remote M&C port. This is specifically intended to simplify remote M&C within the IBS/SMS overhead via the ESC channel. Note this is a `one time` setting, and if the remote M&C parameters are varied, the ESC channel will not follow them. If the remote M&C Baud rate exceeds the maximum continuous ESC rate, then the following warning will be issued, although the copying of the parameters will go ahead.

NOTE: ESC channel not guaranteed above 2962 Baud (YES)

Change, Tx/Rx, ESC/Aux/BA, Set as Remote Warning Menu

P300H P300 Series Modem Installation and Operating Handbook Page 82