Paradise P300 specifications Menu System, Introduction

Main Menu

1:Status 2:Change 3:Monitor 4:Info 5:Log 6:Test 7:Setup 8:Action 9:Help

6 MENU SYSTEM

6.1INTRODUCTION

All configuration & monitoring features are accessed from the front panel via the menu system. Provided an operator has an understanding of how the menu system works, there is no need to try and memorise the menu structure itself, as selecting a single option (SETUP, INITIAL-CONFIG, explained later) will make the unit prompt for all needed configuration parameters. The structure of the menu system is however shown on the next few pages for reference.

THE 1 MINUTE GUIDE TO FRONT PANEL OPERATION

<<<The main menu can be accessed from any display with the MAIN===key. It is from this main menu that all functions are selected.

Whenever the '' or `' symbol appears it indicates that further information is available by pressing theUP or DOWN key.8This information9 is usually worth looking at (otherwise we wouldn’t have put it there !).

The NO key functions as a backstep/backspace key, both when entering numeric data, and when traversing the menus. The YES key doubles as an enter key for numeric entries. Where a numeric entry requires many digits (eg IF frequency), pressing YES after entering all significant digits fills the rest of the entry with zeroes, pressing YES again, enters this value.

When the user is requested to select a configuration parameter, the last setting is always displayed in [square brackets]. To select the same option again, just press the YES Key (ie you don’t have to reselect the same option to get past the menu, just press YES)

Options displayed with a colon eg "1:Status" switch to another screen or subsequent menu but do not affect operation. Options displayed with a equals sign eg "1=Off" change the configuration and may (if changing a relevant parameter) affect the traffic. Reselecting a current option (or pressing YES to select the current option) will never cause a traffic interruption.

When a unit is shipped (or if the non-volatile memory is cleared) it will have an blank configuration and require the operator to use SETUP, INITIAL-CONFIGprior to allowing STATUS to be selected. This prompts for all parameters required for a complete configuration.

Wherever possible menus state “(normal)” after the most common option. If in doubt, select the normal option if there is one, it works every time !

After SETUP, INITIAL CONFIG has been performed once, minor changes to the configuration may be made with the CHANGE option from the main menu. CHANGE allows parameters such as Tx & Rx service/data rates, clocking, IF frequencies, and miscellaneous parameters to be set without going through the entire SETUP process. If however you make a major change to the service (such as switching from Closed Net to IBS) you might decide a quick run through SETUP, INITIAL CONFIG again (accepting the current values with the YES key) will highlight any new parameters (with sensible defaults) that are relevant to this major change of service.

Make use of the Rx=Tx option, it’s great, it cuts down configuration errors, and generally makes life easy. At least read the note on Rx=Tx in section 6.7 on page 86 so you know what you are missing !

P300H P300 Series Modem Installation and Operating Handbook Page 40