P300H P300 Series Modem Installation and Operating Handbook Page 189
APPENDIX C: UPGRADE INFORMATION
INTRODUCTION
To first explain the terms "Software Upgrades", "Hardw are Upgrades", and "Feature Code" upgrades.
Software Upgrades normally involve a vi s i t to our w eb site (http://www.paradisedata.com) to download the
latest version of the modems embedded software. This is then loaded into the modem from a PC through
the modems serial port (on the Async ESC connector) and the PC COM port. Software upgrades can
always be performed in the field.
Hardware Upgrades involve the replacement of printed circuit boards (PCB's), firmwar e (such a s the "Boot
Code"), or cuts/straps to the PCB's to implement hardware changes. Some hardware upgrades can be
performed in the field, and some require a return to the factory.
Feature Code upgrades require the user to enter a f eature code into the front panel of the modem, which
then allows the modem to provides additional facilities. Feature Codes can only be issued by Paradise
Datacom, but the upgrade itself is performed in the field.
THE P300 SERIES MODEM HARDWARE
The P300 Series is a massively redesigned and cost engineered version of our previous P480 modem. It
can provide ever y feature of the P480 (except it has a low es t data rate of 4.8kbps not 2.4kbps) but yet has
only approximately one third the number of components. It relies on the Paradise Datacom T1000
Baseband processing ASIC to provide many of its features.
To provide the cost reduct ion on the base unit (ie the P300-VSAT) , wherever a feature required significant
hardware the hardware has been made optional. However as most of the processing is provided by the
T1000 ASIC, the optional hardware is limit ed to:
The Sequential FEC (a plug in Xilinx chip or module)
The Turbo codec (a plug in module)
The Vite rb i/TCM FEC (a p lu g in chip, no rmal ly fitted but can be removed for Sequential only operation)
The G.703 option card (T1 or E1 variants)
The IDR ESC interface (audio transformers, PCM codecs, full ESC & Aux interfaces)
The Monitor / AGC option (R x carrier level monitoring, a constellation monitor point, and a used defied
analog output signal)
Although these are the only hardware options, many of the features are considered options and are
controlled by `Feature Codes`. Basically this means the features can be turned on and off by a feature code
entered into the front panel.
It may be difficult at first to understand the logic in providing the features within the ASIC, but not having
them enabled on every modem. Quite simply the ASIC which al lows us to provide these featur es was very
expensive to dev elop and thi s i s a cost w e hav e carried in order to provide the com petitive product we offer.
When we are paid extra to enable a feature (which may already be in t he A SIC in the modem you already
have) it is not `m oney for old rope`, it is simply helping us to recover the very large up front costs of
developing the ASIC in the first place. Without the prospect of recovering the ASIC development cost by
charging for the additional features it provides, the ASIC would not have been developed and the modem
would be only half the product it is today.
Upgrading a P300 Series modem may then involve the entering of a `Feature Code` into the front panel,
or the addition of one of more of the optional hardware items listed above in addition to entering of a
`Feature Code` into the front panel.