Paradise P300 specifications Appendix C3 Features on Demo Expire Soon, Do not Ignore this Message

APPENDIX C3: FEATURES ON DEMO EXPIRE SOON

** IF YOU HAVE BEEN REFERRED TO THIS SECTION BY A MESSAGE ** ** ON THE EQUIPMENT DISPLAY, THEN THIS IS VERY IMPORTANT **

The modem is warning you that at least one of the features the modem is using in order to operate as configured is due to expire soon. This means that after expiry, it will cease to function as configured, and one or several of the features required for how it is currently configured will no longer be available.

This Temporary Features mode is usually used to allow customers to evaluate features (eg Drop/Insert, Reed-Solomon) for a finite duration after which the modem reverts back to its standard feature set. Please refer to section C2 to further explain this topic and a description of how to determine which features are required in order to continue operation.

!! DO NOT IGNORE THIS MESSAGE !!

If the features are still in use when the time limit expires then the modem will change it's configuration so it does not require the features which have timed out, and if this in turn causes a change to the transmitted carrier then the carrier will be muted. A message stating “Features not available” will then be displayed showing the letters corresponding to the features which are no longer available. If for any reason you need to keep a modem configuration after timeout (eg to re-use it), then use the configuration memories to store the current configuration before it times out and is changed, and recall it after the features are available again (eg if you instigate a feature test or have a feature code upgrade).

APPENDIX C4: ASYMMETRIC LOOP TIMING

All P300 Series modems have this asymmetric loop timing facility.

APPENDIX C5: UPGRADE AVAILABLE

Again this section is not applicable to the P300 series modems.

APPENDIX C6: FEATURES NOT AVAILABLE

You have been directed to this appendix by a message on the equipment display, as the unit has detected it has been configured to use features which it cannot provide. This is as a result of one of the following:

1)It has been programmed over the remote M&C to use features which it cannot provide. This cannot happen with local control, as locally the configuration screens do not show features which are not available.

2)It was configured to use a certain feature which is no longer available (see Temporary Features

or Test Features in Appendix C2)

Please refer to Appendix C2 (previous page) for a description of the feature list (shown as a series of letters) on the equipment display.

P300H P300 Series Modem Installation and Operating Handbook Page 194