Paradise P300 specifications Protocol, Interface, Address

6.9.2Change, Rem-M&C, CONFIGURE Menu

Remote M&C: 1:Protocol [Paradise]

2:Intfc [RS485] 3:Baud rate[2400] 4:Addr[123]

Change, Rem-M&C, Configure Menu

This menu configures the remote M&C port: The options are:

PROTOCOL	This allows selection between OFF, PARADISE/FDC, and SA-bus. Full details of
	the remote M&C protocols and messages is provided in the Remote M&C section
	in Appendix D.
	NOTE: Remote monitoring is possible with the selected protocol if the protocol
	is not set to OFF. Remote control is only possible if the protocol is not Off and
	control has been selected as Remote on the Change, Remote M&C menu.
INTERFACE	The options available here are RS232 or RS485. RS232 is only usable for a direct
	connection between a single device and a PC. RS485 is required when more than
	one slave device is connected to the remote M&C bus. Again see the Remote
	M&C section for complete details of the electrical interface.
BAUD RATE	The remote M&C Baud Rate is selectable, again see the Remote M&C section
	for complete details of suitable Baud Rates for each protocol.
ADDRESS	The bus address must be specified. The valid range for the Paradise / FDC
	protocol is 1-255, for the SA-bus protocol the valid range of address is 49 to 111
	(31H to 6FH).

P300H P300 Series Modem Installation and Operating Handbook Page 100