6.20.1 Service, USER PARAMETERS Menu

User: 1:Lock Kbd 2:Clr Cfg 3:Clr All+Reset 4:Fan [Auto]

Service, User Parameters Menu

The options are:

LOCK KBD

This locks the keyboard after displaying a screen showing the unlock code. As

 

with all Paradise equipment the unlock code is simply the product number (eg

 

300). The unlock code is displayed before the keyboard is locked on the Modem,

 

as we had quite a few calls to the technical support line which start off “I’ve just

 

selected Lock Keyboard from the menu and ......”

CLR CONFIG

This clears the current configuration down to its default blank state.

CLR ALL+RESET

This clears the entire non volatile memory, including current configuration, all

 

configuration memories, and the traffic log, then resets the processor.

FAN

Normally the fan is temperature controlled, switching on at 26C and off at 24C.

 

The internal temperature can be monitored on the TEST, PSU + TEMP menu. A Unit

 

Warning /deferred alarm will be activated if ever the internal temperature reaches

 

within 3 degrees Centigrade of the operating limits of 0C and 60C. Should the

 

internal temperature exceed the limits of 0C and 60C, then a Unit Fault / Prompt

 

Alarm is activated. The Tx carrier is muted outside the operating temperature

 

range.

6.20.2 Service, FACTORY PARAMETERS Menu

Factory: 1:Serial# [01564] 2:Debug [0] 3:RemCont [Giveaway-120s] 4:Watchdog

Service, Factory Parameters Menu

The options are:

SERIAL #

This menu allows the serial number to be both viewed and edited.

DEBUG

Used for Paradise internal procedures only. Setting Debug to a value other

 

than 0 is very likely to slow down the operation of the unit.

REM M&C

This option is used to set the timeout required before local control can be taken

 

if the unit is in remote mode. This is covered extensively in section Change, Rem-

 

M&C Menu on page 99

WATCHDOG

This provides an option to test the watchdog timer. The watchdog timer is a timer

 

which is regularly reset by the processor. Should it ever reach its set time, then

 

the processor has failed to reset it, and probably crashed. Testing the Watchdog

 

timer therefore will cause the unit to reset, and corrupt both Tx and Rx

 

traffic for a few seconds.

P300H

P300 Series Modem Installation and Operating Handbook

Page 132

Page 132
Image 132
Paradise P300 specifications Range, Traffic for a few seconds