
P100IH ISDN Router
Chapter 2:
Hardware Installation & Initial Setup
2.1.1Front Panel LEDs OF P100IH
The LED indicators on the front panel indicate the operational status of the Prestige 100IH. The following table describes the LED functions:
ISDN Hub Router
|
|
| ISDN |
|
|
| LAN |
| PHONE |
|
PWR | TST | LNK | B1 | B2 | 1 | 2 | 3 | 4 | 1 | 2 |
| Figure |
| Table |
|
|
PWR | The PWR (power) LED is on when power is applied to the Prestige. |
|
|
TST | A blinking TST (test) LED indicates the Prestige is functioning properly. A steady |
| or an off TST indicates malfunction. |
|
|
ISDN: LNK | The LNK (Link) LED is on when the Prestige is connected to an ISDN switch and |
| the line has been successfully initialized. |
|
|
ISDN: B1/B2 | The B1/B2 LED is on when the corresponding B channel is in use. |
|
|
LAN: 1 to 4 | A steady LED indicates an active station is connected to the corresponding port. |
| The LED blinks when the connected station is transmitting. |
|
|
PHONE: 1/2 | The LED is on when the device on the corresponding phone port is in use. |
|
|
Hardware Installation and Setup |