ZyXEL Communications 1001H manual General Setup, Resetting the Prestige

P100IH ISDN Router

ZyNOS firmware file (sometimes referred to as the “ras” file) is the file that contains the ZyXEL Network Operating System firmware and the external firmware file is usually called the router model name with a *.bin extension, e.g., P100IH.bin. Rename the configuration filename to “rom-0” and the firmware filename to “ras” when transferring files to the Prestige (i.e., the internal filenames on the Prestige). Renaming the files is not necessary when you transfer files to the Prestige using the X-Modem protocol.

2.7.1Resetting the Prestige

If you have forgotten your password or for some reason cannot access the SMT menu you will need to reinstall the configuration file. Uploading the configuration file replaces the current configuration file with the default configuration file, you will lose all configurations that you had before and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no parity and 1 stop bit (8n1). The password will be reset to the default of 1234, also.

Turn off the Prestige and begin a Telnet session with the default console port settings. Turn on the Prestige again. When you see the message "Press Any key to enter Debug Mode within 3 seconds", press any key to enter debug mode. You should already have downloaded the correct file from your nearest ZyXEL FTP site.

2.8General Setup

Menu 1 - General Setup contains administrative and system-related information.

To enter Menu 1 and fill in the required information, follow these steps:

Step 1. Enter 1 in the Main Menu to open Menu 1 – General Setup.

Step 2. The Menu 1 - General Setup screen appears, as shown below. Fill in the required fields marked [?] as shown in the following table.

Menu 1 - General Setup

System Name= p100ih

Location= branch

Contact Person's Name= JohnDoe

Press ENTER to Confirm or ESC to Cancel:

Figure 2-7 Menu 1 – General Setup

2-8 Hardware Installation and Setup