ZyXEL Communications 1001H manual Remote Node Filters, Filtering Remote Node traffic

P100IH ISDN Router

9.4.2Remote Node Filters

Go to Menu 11.5 (shown below) and enter the number(s) of the filter set(s) as appropriate. You can cascade up to four filter sets by entering their numbers separated by commas. The factory default filter set, NetBIOS_WAN, is inserted in protocol filters field under Call Filter Sets in Menu 11.5 to block local NetBIOS traffic from triggering calls to the remote node.

Menu 11.5 - Remote Node Filter

Input Filter Sets: protocol filters=

device filters= Output Filter Sets: protocol filters= device filters=

Call Filter Sets: protocol filters= 1

device filters=

Factory Default Filter

Figure 9-11 Filtering Remote Node traffic

9.4.3Default Dial-in Filter

Use Menu 13.1 – Default Dial-in Filter to specify the filter set(s) to apply to the incoming and outgoing traffic between all dial-in users and your Prestige. Note that these filter set(s) only apply to the dial-in users but not the remote nodes. You can specify up to 4 filter sets separated by comma, e.g., 1, 5, 9, 12, in each filter field. The default is no filters.

Menu 13.1 - Default Dial-in Filter

Input Filter Sets: protocol filters=

device filters= Output Filter Sets: protocol filters= device filters=

Figure 9-12 Default Dial-in Filter

9-16 Filter Configuration