Appendix C IR-ETH/V Interface Module RIC-E1 Installation and Operation Manual
C-4 Installation and Operation
C.3 Technical Specifications Bridge LAN Table 2,048 MAC addresses
Aging 5 minute, automatic
Latency
(Frame size 64 bytes)
10 Mbps full duplex, 360 µs
100 Mbps full duplex, 285 µs
Throughput 4050 pps with 64 byte frame length and increment byte
data (00, 01, 02, …)
Buffer Size 120 frames (Frame size 64 bytes)
LAN Standard IEEE 802.3/Ethernet V.2, IEEE 802.1q (relevant parts),
802.1p, 802.3x
Data Rate 10BaseT: 10 Mbps
100BaseT: 100 Mbps
Transmission Line 4-wire, Category 5 UTP, 19 AWG to 26 AWG
Line Code 10BaseT: Manchester
100BaseT: MLT3
Packet length Up to 1536 bytes
Connector RJ-45 (Automatic MDIX support)
WAN Protocol Point-to-point
Data Rate Up to 2048 kbps
Priority Queues 2
C.4 Installation and Operation Figure C-4 shows the DIP switch locations and the default settings of the
IR-ETH/V PCB.
The screen print tables on the IR-ETH/V PCB are look-up tables of the function
enabled settings. The tables do not show the default settings.
For example, MDI in OFF position, MDI is enabled.
SW2
ON
5.
6.
4.
3.
2.AN
FDX
NC
NC
NC
1.100
SW1
5.
7.
6.
8.
4.
3.
2.NC
NC
FLC
FIL
NC
FP
NC
1.MDI
ON
Figure C-4. SW1 and SW2 DIP Switch Locations
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com