The Basics
3. Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the bottom of the base.
4. Route the adapter’s cord through the strain relief slot on the base of the phone. Then plug the adapter into a standard AC outlet.
CAUTION: You must use a Class 2 power source that supplies 9V DC and delivers at least 400 mA (for the base)/210 mA (for the charger). Its center tip must be set to positive and its plug must fit the phone’s DC IN 9V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the phone or the adapter.
On a Wall Plate or Wall
To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the base.
Drill two holes 3 15/16 inches apart. Thread a screw into each hole, letting the heads extend about 1/8 inch.
1.Plug the supplied AC adapter’s barrel plug into the DC IN 9V jack on the bottom of the base.
2.Route the adapter cord through the base’s groove.
3.Plug one end of the supplied modular cord (short for a wall plate, long for direct wall mounting) into the TEL LINE jack on the bottom of the base.
16
