Radio Shack PRO-528 manual Wired programming

Beyond the Basics

To turn it off, hold down /KEYLOCK

until disappears.

Note: Using keylock does not prevent

Notes the scanner from scanning channels.

wired programming

You can transfer programming data to your scanner using your PC and an optional interface cable (available at your local RadioShack store) and software (available at your local RadioShack or www.radioshack.com).

Note: If the scanner receives no

data from the PC for more than 20 Notes seconds, T-Errappears and wired

programming stops.

1.Make sure your scanner is turned off.

2.Connect the interface cable to your computer and then connect the other end of the cable to PC/IF on the side of the scanner.

3.Install the software to your computer and run the program.

4.To set up the program, click on Tools, select Configuration, and select PRO- 528 (if necessary).

5.Turn the scanner on. The scanner automatically goes into the wired programming mode. PGM and WirEd

36