Beyond the Basics
Type II systems. Set the scanner to receive Type I trunked frequencies. See “scanning type I and hybrid trunked systems”.
The selected fleet map is incorrect. Try another preset fleet map or program your own fleet map (see “scanning type I and hybrid trunked systems”).
Enter all of the trunk’s frequencies: see “programming trunked frequencies”.
How do I reset my scanner?
If the scanner’s display locks up or stops operating properly, you might need to reset the scanner.
Caution: This procedure clears all the information you have stored in the scanner. Before you reset the scanner, try turning
it off and on to see if it begins working properly. Reset the scanner only when you are sure it is not working properly.
1.Turn off the scanner.
2.While holding down 2, 9 and HOLD/ RESUME, turn on the scanner. CLEAr flashes for about 5 seconds as the scanner clears its memory.
Note: Do not turn off the scanner Notes again until CLEAr stops flashing.
Otherwise, the scanner might not clear its memory properly.
83
