Model CC639 Only: Remote Control
Model CC639 Only: Lithium Cell Installation
The remote’s lithium cell is packed separately. Install it as follows:
Back of
Remote Control
Insert Pencil Here
Lithium Cell 
Belt Clip
Holder
1.Turn remote over, insert a pencil or paper clip in the small hole, and slide it in the direction of the arrow while removing the holder.
2.Insert the lithium cell into the holder with its positive (+) terminal facing up.
3.Slide the cell in the holder back into the remote until it clicks into place.
Remote Sensor
Cautions: Lithium cell battery. Replace only with
Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the + and – sides of the cell.
Notes: Never place anything heavy on top of the remote or lay it
Replace the cell when the camcorder fails to respond to the remote.
Remove the cell from the remote if it will not be used for a month or more. This will prevent possible damage from cell leakage. If leakage occurs, wipe up the liquid inside the compartment and replace the cell.
The remote operates the camcorder by infrared light, so it is protected from electrical and sound interference. However, the remote must be aimed directly at the camcorder’s remote sensor. There cannot be any obstructions between them.
MENU
16X9 AE MODES
EIS
FADE
WIPE
Remote Control Sensor
AUTO | H |
| S |
| U |
| P |
US |
|
FOC |
|
MANUAL |
|
PHOTO |
|
DATE/ EFFECTS |
|
TIME |
|
Notes: The camcorder may not respond to the remote if its sensor is exposed to direct sunlight or strong artificial light.
You can program the remote to also operate a compatible VCR while copying or editing tapes. Details are on pages
17
