RCA CC638/639 manual Date/Time Display Install the Clock Lithium Cell, To remove battery

Recording

Date/Time Display — Install the Clock Lithium Cell

The clock cell indicator will flash for a few seconds in the viewfinder when you turn on the camcorder if the cell has not been installed or needs to be replaced.

Insert object here to remove cell.

Clock Cell

(+ Side Facing Out)

– + B

Clock Cell
Compartment		POWER
		VCR
		OFF
		CAMERA
		AUDIO
BATT.		RF
	RELEASE	DC OUT
		VIDEO

L E N S

C O V RE

1.Make sure camcorder is turned off, and remove any power supply attached to the camcorder.

2.Press release tab of clock cell compart- ment cover and open the compartment.

3.Insert the clock cell with the “+” terminal facing out.

4.Close the compartment cover. It will click into place.

To remove battery

To remove battery, insert a pointed non- metallic object between battery and compartment and lift.

Cautions: Lithium cell battery. Replace only with 3-volt lithium cell – such as CR2025. Use of other cell presents a risk of fire or explosion. Must be disposed of properly. Never handle punctured or leaking cell. May cause burns or personal injury.

Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.

The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.

Never use metallic tweezers to hold the cell, and never short circuit the + and – sides of the cell.

55