Runco VX-3000D operation manual Turning on the Power, Connecting to AC Power

Installation

Projector/DHD Controller: Plug the female end of one power cord into the AC receptacle on the rear of the VX-3000d (AC 100V ~ 240V). Then, connect the other end to your AC power source.

Similarly connect the DHD Controller to a nearby AC outlet.

AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power cord is provided for the lens motor. Plug the female end of the AC power cord into the AC input on the rear of the lens motor assembly. Connect the other end to your AC power source.

1.Turn on your source components.

2.Turn on the main power switch at the rear of the DHD Controller.

3.If this is an AutoScope-equipped projector, turn on the main power switch at the rear of the AutoScope lens motor. The lens motor power switch is located next to the AC input.

4.Turn on the main power switch at the rear of the projector. The POWER LED lights orange. The LAMP and TEMP LEDs light red briefly, then go out.

5.Press the ON button on the remote control (or the ON/STANDBY ( ) button on DHD Controller front panel) to turn on the system. The vacuum fluorescent display on the DHD Controller front panel briefly displays “Initializing System,” followed by “Starting VX-3000d.” On the projector, the POWER LED flashes green to indicate that it is warming up.

6.When the projector is ready for use, the POWER LED lights solid green. On the DHD Controller, the fluorescent display indicates the active source, input resolution/frame rate and aspect ratio; for example:

Current

Source

Connecting to AC Power

3.8

Turning on the Power

VX-3000d HDMI 1

16:91080i/60

Aspect Ratio Input Resolution/Frame Rate

VX-3000d Series Installation/Operation Manual 49