
Installation
Adjusting the Lens Height (Y):
1.Project a white field on the screen.
2.Ensure that the four Height (Y) Adjustment Screws are loose enough to allow vertical movement of the lens assembly.
3.Slowly move the anamorphic lens into place so that there are no shadows on the top or bottom of the screen:
Too Low
Correct position
Too High
4.When the height is properly set, tighten the Height Adjustment Screws to secure the lens in place.
Adjusting the Pitch (Angle): Next, angle the lens to even out any
Correct Lens Angle
Incorrect Lens Angle
The anamorphic lens will almost always be angled with respect to the projector; this is normal.
Once the proper lens angle has been set, firmly tighten the Pitch Adjustment Screws to secure the lens in place.
There may be some pincushion distortion even after the lens is
Note properly adjusted, especially at shorter throw distances. If this is the case, Runco recommends that you slightly
58 |