Installation

5.Use the Height/Y Adjustment T-Screws/Washers (item #3), Pitch Adjustment T-Screws/Washers (item #4) and T-Nuts (item #9) to attach the Pitch Adjustment Yoke and Lens Adapter Ring to the Anamorphic Lens Holder. The Yoke should be as close to the primary lens as possible.

6.Attach the lens to the Lens Adapter Ring by threading it clockwise.

Lens threads into ring

SUCO

F

Figure 3-24. Attaching the Anamorphic Lens to the Lens Ring

Configure Lens Motor Trigger (VX-3000d/CineWide with AutoScope only):

CineWide with AutoScope maintains constant image height independent of the aspect ratio, while using the full display resolution of the projector. It accomplishes this by moving the anamorphic lens in front of the primary lens when widescreen material is being viewed. When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens moves out of the light path.

To configure the lens motor trigger on the DHD Controller for proper AutoScope operation:

1.Project a 2.35:1 aspect ratio test pattern or other image on the screen.

2.On the DHD Controller remote control or front panel, press MENU.

3.Select Service from the Main Menu and enter the Service Menu passcode.

Note

You must enter a passcode to access the Service menu for the first

time after turning on the system.

VX-3000d Series Installation/Operation Manual

53

Page 69
Image 69
Runco VX-3000D operation manual Time after turning on the system