Installation
12.Gently push the lens assembly in until it is seated flush against the flange and the guide pin on the lens assembly is fully seated in the hole on the flange.
Guide Pin
Guide Pinmates with this hole
13.Secure the lens assembly to the projector flange with the three Allen screws on the outer ring of the assembly, using a
hex driver.
Tighten only these three screws. Do not attempt to adjust any of the Caution screws behind the lens flange. Doing so may cause the lens to
malfunction.
14. Install the foam shield around the front of the lens.
15.Replace the front lens bezel.
16.Tighten the Phillips screw on the bottom of the bezel to secure it.
27 |
