Runco VX-3000D operation manual Whitney Prismatic, Anamorphic Lens, Installation

Installation

The Whitney Anamorphic lens mount kit consists of everything shown in Figure 3-25.	Whitney (Prismatic)
Some components shipped with your projector may differ slightly from what is shown in	Anamorphic Lens
these instructions.	Installation and
	Adjustment
1 Anamorphic Lens

6 Pitch/Y-Adjustment

Screw, Phillips

Pan Head, 4-40 x 3/8”

(4x) and Fender

Washer (4x)

2 Base Plate

3Screw, Phillips M6x16mm (2x) and 1/4” Flat Washer (2x)

(not shown; secures Base Plate to bottom of projector)

5Vertical Mounting Bracket (2x)

4Yaw/Z-Adjustment Knob (2x) and Washer (2x)

Figure 3-25. Prismatic Anamorphic Lens Mounting Assembly - Exploded View

1.Use the Pitch Adjustment Screws and Washers (item #6) to attach the Vertical Mounting Brackets (item #5) to the Anamorphic Lens (item #1).

2.Place the lens with the brackets installed on top of (or under, if the projector is inverted) the Base Plate (item #2), so that the two threaded posts at the bottom of the brackets pass through the corresponding slots on the base plate.

3.Secure the lens assembly to the base plate with the Yaw/Z-Adjustment Knobs and Washers (item #4).

Tip	To avoid clipping the corners of the image, position the anamorphic
	lens as close as possible to the primary lens.
		Ceiling Mount
		Bracket

VX-3000d Series Installation/Operation Manual 57