Runco XP-50, XP-65 operation manual Or 1080p and the Aspect Ratio is set to 169 refer to, Sound

Operation

Note	1. 1:1 PIXEL MODE is available only when the input signal is 1080i
	or 1080p and the Aspect Ratio is set to 16:9 (refer to page 23).

2.You cannot adjust H-SIZE,V-SIZEor DOT CLOCK when 1:1 PIXEL MODE is enabled.

Use the controls in the SOUND menu to adjust the CinemaWall audio settings. SOUND

To return all SOUND menu settings to their factory-default values, press RESET on the remote control unit with the menu on-screen. Or, press or repeatedly to highlight RESET in the menu, then press the ACTION () button.

SOUND

RESET
	NORMAL
AUDIO MENU						DYNAMIC
BASS
					0
MID				0
TREBLE				0
BALANCE				0
SURROUND						ON
AUDIO OUT (PIP)						MAIN
			RETURN
		RESET
	ADJUST
		SELECT

AUDIO MENU: The CinemaWall provides three audio memories for storing and recalling sound quality settings. To store settings in an audio memory, highlight AUDIO MENU in the SOUND menu and select STANDARD, DYNAMIC or CLEAR. The CinemaWall “remembers” any adjustments you make when you switch to a different audio memory, then switch back.

BASS/MID/TREBLE: Use these controls to boost or cut the low, mid-range and high frequencies respectively in the audio signal.

BALANCE: To adjust the left/right speaker balance, select BALANCE from the SOUND menu. Use the or buttons to make one channel louder than the other.

SURROUND: The CinemaWall has a “surround sound” mode that simulates a multi-channel sound system. To use the surround mode, select SURROUND from the SOUND menu and set it to ON.

AUDIO OUT (PIP): To swap the main and PIP audio programs when using the

MULTI PIP feature, select AUDIO OUT (PIP) from the SOUND menu and set it to either

MAIN or SUB. For more on MULTI PIP mode, refer to MULTI PIP SETUP on page 43.

CinemaWall XP-50/XP-65 Installation/Operation Manual 37