Default configuration on the wide area network side | Sagem 1500

Appendix E - Default configuration

E.4 Default configuration on the wide area network side

WAN characteristics	Function - Mode	State/Value
ATM characteristics	Protocol	PPPoA

	VPI	8

	VCI	35

	Encapsulation	VC MUX
	QoS Class	UBR
	PCR	4000 cells/s
	SCR	4000 cells/s
	MBS	10
	NAT	Enabled
	Default route	ADSL interface address
	DNS relay	Enabled

	Firewall	Enabled

	Intrusion detection	Disabled

	OAM F4 and F5 (see Note)	Enabled

Note: The OAM functions provided are as follows:

-Segment and end-to-end flow F4 and F5 management by VC.

-AIS/RDI functions.

-Response to loopback cells F4 or F5.

-Response to continuity check (CC) enable/disable cells.

PPP characteristics	IP address	Automatic negotiation

	MTU	1400

	Connect Type	Always Connected

Remote Management	Access	Disabled

ADSL characteristics	Maximum upstream rate	896 kbit/s

	Maximum downstream rate	8160 kbit/s

	Mode	Multimode

	Latency	Simple latency (fast or interleaved)

Note: The user can revert to the default configuration via the HTTP interface.

E.5 Default configuration for advanced functions

Advanced functions	Function - Mode	State/Value
characteristics
	UPnP	Enabled
	DDNS	Disabled

SAGEM F@st™ 1500 Reference Manual - 288053220-04 Reproduction and communication prohibited without the written permission of E Page E-3

Image 135

Sagem 1500WG manual Default configuration on the wide area network side, Default configuration for advanced functions

Contents

288 053 Reference ManualPage Contents Configuring the Sagem F@st 1500 Adsl router Appendix C Cables Appendix a Troubleshooting Appendix B Safety warningsAppendix D Technical specifications Appendix E Default configuration Front Panel List of figures Introduction About the Sagem F@stTM 1500WG Adsl Router Features and BenefitsWireless and Wired LAN Internet Access Security Shared IP AddressVirtual Server DMZ Host Support Composition of the supply Prerequisites Introduction Description and Physical installation Hardware Description Description and physical installation Status Description Front panel Ports / Button Description ResetPower Rear panel Environment Physical Installation Installation instructionsPower supply source Maintenance Desktop Installation Settings and Connecting ISP settings Install the Sagem F@stTM 1500 Adsl RouterConnect the Adsl Line Installing a Full-Rate Connection Phone Line Configuration Installing without a splitter Installing a Splitterless Connection Connect the Power Adapter Attach to Your Network Using Ethernet Cabling Powering up the Sagem F@st 1500 Adsl router Description and physical installation Configuring Client Computer TCP/IP Configuration MacIP Address 192.168.2.1 Subnet Mask 255.255.255.0 Millennium Edition is similar, but not identical, to Windows Configuring your Windows computer On Windows 98 / Me TCP/IP Configuration Setting Internet Explorer Disable Http Proxy Configuring Client Computer Obtain IP Settings from Sagem F@stTM 1500 Adsl Router On Windows NT On the Windows desktop, click Start/Settings/Control Panel Configuring Client Computer TCP/IP Configuration Setting Configuring Client Computer On Windows Disable Http Proxy Obtain IP Settings from Sagem F@stTM 1500 Adsl Router Configuring Client Computer On Windows XP Disable Http Proxy Obtain IP Settings from Sagem F@st1500 Adsl Router Configuring Client Computer Configuring your Mac computer Disable Http Proxy Configuring Client Computer Configuring the Sagem F@st 1500 Adsl router Sagem F@st Configuring the Sagem F@st 1500 Adsl router Sagem F@st 1500WG Navigating the Management Interface Setup Wizard Advanced Setup Making Configuration Changes Status Information LAN / WirelessDescription Additional PPP Setting Setup Wizard menu Essid Broadcast Wireless ModeChannel and Ssid Parameter Description Parameter Description 3 WEP Access Control System Time Settings Password Settings Configuration tools Choose a function and click NextYou will be asked to confirm your decision Reset Firmware Upgrade WAN menu Bridging ATM PVC CBR Clone MAC LAN Domain Name VlanParameter Description IP Address Pool Start IP End IP Add Vlan Edit Enter those addresses on this page, and click Apply 2 DNS Wireless Wireless Mode Ssid BroadcastChannel Access Control Security 4 WEP 5 WPA Configuring the Sagem F@st 1500 Adsl router Parameter Description 802.1X Authentication Session Idle timeoutRe-Authentication Re-Type Password NAT Address Mapping Virtual Server Special Application NAT Mapping Table Firewall Access Control Configuring the Sagem F@st 1500 Adsl router MAC Filter URL Blocking Click Add Schedule Rule Schedule Rule Intrusion Detection Feature Intrusion DetectionStateful Packet Inspection Configuring the Sagem F@st 1500 Adsl router Connection Policy DoS Criteria and Port Scan Criteria 6 DMZ Static Route Route 2 RIP Version Operation ModeParameter Description General RIP Parameters Table of current Interface RIP parameter Interface Routing TableParameter Description Flags Netmask Please complete the Minimum Bandwith Allocation Parameter Description Enable or disable QoS module function10 QoS Diffserv Forwarding Groups Traffic Mapping Parameter Description Traffic statistics Adsl Advanced Monitoring Index Loss of Signal Defect Parameter Operation Mode DescriptionFast Path CRC Error Interleaved Path CRC Error Remote Management Snmp Snmp Setting Snmp Trap UPnP Ddns Macintosh Finding the MAC address of a Network CardWindows 98/ME Windows NT4/2000/XP Configuring the Sagem F@st 1500 Adsl router Appendix a Troubleshooting Management Problems Troubleshooting ChartSymptom Action LED Indicators Network Connection Problems Symptom Action LED Indicators Wireless Problems Appendix a Troubleshooting Appendix B Safety warnings LAN Ports Safety warningsSafety levels on the mains adapter unit Safety levels on the Sagem F@st 1500 unit Safety CE declaration of conformityRadio specific to Sagem F@st 1500WG Appendix B Safety warnings Appendix C Cables 3 RJ-45 Port Connection SpecificationsWiring Conventions Ethernet cable General Straight-Through WiringCrossover Wiring Pin Assignments Line Standard Telephone cable RJ11 Cable Types and SpecificationsCable Type Connector Adsl Cable Pin Signal Name Wire Color Figure C.2 RJ-11 Connector Pin Numbers Appendix C Cables Appendix D Technical specifications Input Power Mechanical Characteristics DisplaysElectrical Characteristics Adsl Features Security Features Soft Component FeaturesATM Features Management Features Radio Features Operating Channels Ieee 802.11g compliant RF Output Power Modulation Rate-Output Power dBmModulation Rate-Output Power dBm Operating Channels Ieee 802.11b compliant Modulation Rate-Receiver Sensitivity Typical dBm Environmental characteristics Internet Standards Appendix E Default configuration LAN characteristics Function Mode State/Value Default user name and password for Http accessDefault language for Http User Interface Default configuration on the local area network side Advanced functions Function Mode State/Value Default configuration on the wide area network sideDefault configuration for advanced functions WAN characteristics Function Mode State/Value Appendix E Default configuration Page ENetworks Division