Using the camera button to adjust the camera

The STILL IMAGE / MOVIE CLIP mode function can be set up by using the camera button.

POWER switch

Used for turning the camera power on / off.

If this camera isn’t operated during the specified time(about 60 SEC.), the camera power will be idle(LCD monitor : Off, Mode

dial lamp : ON ) automatically. To use the camera again, press any of the camera buttons

except the power switch.

If there is no operation during the specified time after the idle

mode, the camera power will be turned off automatically to save battery life.

Pressing the power button for over 2 seconds will deactivate the buzzer sound function.

If you wish to hear the buzzer sound, set the [SOUND] settings in the SETUP mode to ON.

SHUTTER button

Used for taking an image or recording audio in the RECORDING (STILL IMAGE, MOVIE CLIP) mode. In MOVIE CLIP mode

Pressing the shutter button down fully starts the process for recording a movie clip. Press the shutter button once and the movie clip is recorded for as long as the available recording

time in the memory allows. If you wish to stop recording, press the shutter button again.

In STILL IMAGE mode

Pressing the shutter button down halfway activates the autofocus and checks the condition of the flash. Pressing the shutter down fully takes the image and stores the relevant data regarding the shot. If you select voice memo recording, the recording will start after storing the image data is complete.(Voice Recording time : 10sec)

28

Page 28
Image 28
Samsung 420 manual Power switch, Shutter button, Used for turning the camera power on / off