The SET button |
The device buttons |
Scanning method
To use the scanning method to program your DIRECTV Receiver’s remote control, follow these steps:
1Turn on the device you want to control.
2Aim the remote control at the device.
3Simultaneously press the SET button and the device button for the device you want to program your remote control to operate, (the TV button, for example).
The device button lights up.
4Repeatedly press the CH+ or CH- button to scan through the device codes. The device button will blink each time you press the CH+ or CH- button.
5When the device turns off, stop pressing the CH+ or CH- buttons.
6Press the device button again.
The button blinks twice and then turns off.
7Repeat the procedure for other devices you wish to operate with your DIRECTV Receiver’s remote control.
Operating a device with your programmed remote control
To operate a device using your programmed remote control, you must first press the corresponding device button (TV, VCR, DVD, AUX, or DIRECTV). Then use the remote control to operate that device. The remote control will continue to operate that device until you press another device button.
Each time you want to switch to a different device with your remote control, you start by pressing a device button.
106
