JIf this port is changed, communication to the SAMS Communication Server Basic may not establish. If changed this port, make the same change to the SAMS Communication Server Basic too.

6.Check whether the [Use] is checked.

JIf [Use] is not checked, communication to the corresponding communication server will not establish. This can be used when intended not to connect temporarily to a specific server.

7.By using the [Connection Test], check if SAMS Basic properly connects to the SAMS Communication Server.

8.Click Save <> in the tool bar.

LOOP SETTING (SERIAL COMMUNICATION)

Up to 100 loops can be assigned for each site, up to 32 controllers can be connected to each loop in serial communications (may vary depending on controller specifications). For networked communications, one loop can be connected to one controller.

1.From the upper menu, select [System Management] > [Loop Setting].

SETUP INITIAL & IN LOGGING

2.Select a [Site].

3.Enter the [Loop].

4.Select a [Communication Type]. Select [Serial Communication] if communication to the device is serial.

5.Check [Whether to use].

English _49