Samsung SSA-M1000 SSA-M1000/EXP DEVICE SETTING, English _53

DEVICE SETTING

For serial communications, configure devices connected to each loop. For network communications, configure one connected device for each loop.

1. From the upper menu, select [System Management] > [Device Setting].

SETUP INITIAL & IN LOGGING

2.Select a [Site].

3.Select a [Loop].

4.Select a [Device Type]. Select [Controller] for access controller device, or select [Biometrics Reader] for biometrics/fingerprint readers.

J SSA-P102, SSA-P40x, SSA-S21xx, SSA-S30xx series products are controllers, and SSA-R20xx series products are biometrics readers.

5.Select the product type for the device to be configured in [Product Type].

6.Select [Device Door Type]. Door Type varies depending on the devices.

J SSA-P102, SSA-S21xx, SSA-S30xx series products are 1-door type. SSA-P40x series products are 2~4 Door type.

7.Select the [Device Address]. Each controller has its own address for communication.

J Setting the communication address differs from product to product. For setting the device’s communication address, refer to the product documentation for further details.

Note that communication addresses configured in SAMS Basic and corresponding device must match for proper communication between them.

English _53