Replacing Consumables and Maintenance Kit
K Hold the Fuser Oil Unit in the manner shown in the illustration. Match (U) on the front of the Fus- er Oil Unit and (T) on the Fusing
1 Unit at three places. While push- ing the green lever on the left side of the Fusing Unit (A), insert the left and right protrusions of the Fuser Oil Unit into the white holders of the Fusing Unit (B), and then move the Fuser Oil Unit in the direction shown by the ar- row (C) to attach the Fuser Oil Unit to the Fusing Unit.
ZDJH054E |
L Holding the green handle with one hand, use your other hand to push the front area of the handle to create a slight slant, and push the Fusing Unit slowly to the back.
ZDJH050E |
Note
❒Confirm that the Fuser Oil Unit is facing the inside of the print- er.
At this point, make sure the Fusing
8Unit is on the stand properly.
M Close the upper left cover (A) and push the handle slowly (B) to the back until it clicks into place.
ZDJH051J |
N Place the old Fuser Oil Unit into the bag which contained the new Fuser Oil Unit, and seal the bag.
O If you removed the External Tray in step D, reattach it to the printer. Insert the hooks of the External Tray into the printer slits, and lower it toward you.
ZDJH010J |
P If the Duplex Unit is installed, close the Duplex Reversal Unit.
Reference
See P.2 “Opening and Closing the Duplex Reversal Unit”
Q If the 2 Tray Finisher was in- stalled, reattach the 2 Tray Finish- er to the printer.
Reference
See P.1 “Detaching the SR770 (2 Tray Finisher)”