Savin SLP38C Paper Recommendations, Loading Paper, Storing Paper, Types of Paper and Other Media

Appendix

Paper Recommendations

Loading Paper

Important

❒Do not use paper that is meant for an ink-jet printer or it may stick to the Fus- ing Unit and cause a paper misfeed.

❒When printing on an OHP transparency that has a print side, load it with the

3	print side over on the Bypass Tray. Not taking this precaution may cause it to
	stick to the Fusing Unit and cause a misfeed.

❒Print quality cannot be guaranteed if recommended paper is not used. For de- tails about recommended paper, contact your sales or service representative.

❒Do not use paper that has already been printed onto by other printers.

Storing Paper

•Paper should always be stored properly. Improperly stored paper might re- sult in poor print quality, paper misfeeds, or printer damage. Recommenda- tions are as follows:

•Avoid storing paper in humid areas.

•Avoid exposing paper to direct sunlight.

•Store on a flat surface.

•Keep open reams of paper in the package in which the paper came.

Types of Paper and Other Media

❖Plain Paper

•Tray 1/2 can hold up to 500 sheets.

PAPER FEED UNIT Type 3800C (500x1) can hold up to 500 sheets. PAPER FEED UNIT Type 3800C (500x2) can hold up to 1000 sheets. Paper Bank PS470 can hold up to 2000 sheets.

Confirm that the top of the stack is not higher than the limit mark inside the tray.

•Bypass Tray supports custom size, approximately 3.5 - 12 inch in width, and approximately 5.8 - 18 inch in length.

•When printing on the reverse side of plain paper that is already printed on, you should load it on the Bypass Tray and select [Plain (Duplex Backside)] from [Paper Type:] with the printer driver.

52