UPS Control, Source 2 input measurement | Schneider Electric 66846

Network

Management Card

User Manual

3.2.6.1 Source 2 input measurement

Source 1 current

Source 1 voltage Phase / Phase

Source 1 frequency

Source 1 neutral current (if wiring 3 phases + neutral)

3.2.6.2 Source 2 input measurement

Source 2 current

Source 2 voltage Phase / Phase

Source 2 frequency

Source 2 neutral current (if wiring 3 phases + neutral)

3.2.7 UPS Control

Click on the “UPS Control” section in the menu.

If the UPS is not compatible with this function, a warning message is sent to the user.

UPS configuration may also prevent the commands from being properly run. Read the UPS manual for more information.

This page enables triggering of startup and shutdown sequences for the UPS main output

The status of output is displayed by a symbol associated with the Off label (red symbol) or Powered (green symbol).

Network Management Card – User Manual

34003676EN/HA

Page 22/81

Image 22

Schneider Electric 66846, 66074 user manual UPS Control, Source 2 input measurement

Contents

Network Management Card NMC Transverse Environment Sensor Network Management Card MAINTENANCE72 Software Upgrade ConfigurationConfiguration VIA Telnet Configuration VIA SSH Appendices Tables of Alarms and Events Glossary Introduction Connecting the UPS / STS to the NetworkNetwork Management Card Monitoring the UPSs over the network MGE supervisor Enterprise Power ManagerProtecting the computers / servers Network Shutdown module only available for UPS, not for STS Connection How to connect UPS / networkSetting up the protection, for UPS only Presentation of the Network Management Cards NMC Direct sending of E-mail Presentation of the Environment Sensor solutionSending text messages SMS Technical data 10/81 Basic configuration InstallationEnvironment Sensor Supervision / Administration via a Web browser Optimising the performance of your browser UPS zone general information on the UPS UPS / STSUPS properties UPS status zone essential information Battery status zone STS zone general information on the STS STS propertiesSTS status zone essential information About Sources status zone On-line help 18/81 UPS 3-Phase display Normal input measurements Battery measurements By Pass measurements STS 3-Phase display UPS Control Source 2 input measurement 23/81 UPS weekly schedule programming Shutdown parameters Important note Viewing the alarms Logs UPS Measurements STS Measurements 29/81 UPS Event log STS Event log 31/81 System log 33/81 UPS Email Notification NotificationNotified events Mail message configuration see next Recipient List Other settings STS Email Notification Sender Email Message SettingsUPS Email Message Settings Subject STS Email Message Settings Email Example Configuration User Name and password by default are Mgeups Network Settings 42/81 System 44/81 UPS Notified Applications 46/81 Central Shutdown Configuration STS Notified Applications 49/81 Access control 51/81 Access is disabled and the card is accessible in SSH Time Status Configuration Log CharacteristicsEnvironment Environment status 56/81 UPS Environment Settings UPS Environment Settings STS Environment Settings Humidity 4 Log Set-up of the shutdown parameters Shutdown criteria managed by the Management Card Shutdown when backup time is less than Specific set-up for long autonomy installation 30 mnShutdown duration Different server and UPS shutdown sequences 63/81 4 Off/On command Configuring a set of cards with Mupgrade Configuration in local mode Choice 1 Snmp agent configuration menu Mgeups Choice 3 Access control Choice 2 UPS / STS parameters Choice 4 Restore default configuration Choice 5 Reset the card Configuration via SSH Configuration via TelnetPuTTY SSH Client Program 70/81 71/81 Card firmware upgrade using Mupgrade Windows Software upgradeCard software upgrade via Tftp Unix and Windows STS Alarm table Tables of alarms and eventsUPS Alarm table English French UPS event table UPS STS event table 77/81 System alarm table Glossary Subnet mask Telnet Trap Snmp