Schneider Electric PAS4S Electrical installation, Checking installation, Connecting the sensors

PAS4•S 4 Installation

MNA1MLSDM00EN, V2.01, 07.2009

4.3Electrical installation

4.3.1Connecting the sensors

The sensors are equipped with an M8 x 1 connector.

	4							+					+
				1						1
1 (+)		3 (-)			4						4
			PNP						NPN
	M8			3			-			3		-
Figure 4.2 Connection assignment sensors
Pin	Description					Color
1	PELV supply voltage (+)					BN (brown)
3	PELV supply voltage (-)					BU (blue)
4	Output					BK (black)

The cable length is 100 mm. Extension cables are available in various lengths as accessories, see chapter 7 "Accessories and spare parts".

4.3.2Motor connection

See the motor manual for details on connecting the motor.

4.4Checking installation

Verify that you have correctly installed the product after having per- formed the above steps.

￿Verify correct mounting and cabling of the product. In particular, check the mains connection and the 24V connection.

Check the following:

￿Did you connect all protective ground conductors?

￿Do you use correct fueses?

￿Are any live cable ends exposed?

￿Did you properly install and connect all cables and connectors?

￿Did you properly install the sensors?

￿Do the sensors function as required?

￿Is it possible to freely move the carriage with the contact plate for the sensors along the entire travel length?

Portal axes with ball screw drive 55