PAS4S

6 Diagnostics and troubleshooting

 

 

6.3Replacing parts

Only replace the parts described. All other parts may only be replaced by technicians trained by the manufacturer.

Carry out a complete installation for replacing the entire axis as per see chapter 4 "Installation".

Adjust and check the linear axis as per chapter 5 "Commissioning" after replacing parts.

6.3.1Replacing a sensor

You can replace a sensor without changing the position of the sensor holder.

Unless otherwise specified, the standard tightening torques indicated on page 47 apply.

Prerequisites

Procedure

1

3 2

See chapter 7 "Accessories and spare parts" for suitable spare parts.

You need a set of Allen keys and a feeler gauge.

￿Loosen the M3 screw (2) at the slotted side of the sensor holder until the sensor to be replaced can be pulled out from below.

￿Mount the new sensor as described on page 50.

MNA1MLSDM00EN, V2.01, 07.2009

Portal axes with ball screw drive

61

Page 61
Image 61
Schneider Electric PAS4S manual Replacing parts, Replacing a sensor