PAS4•S | 6 Diagnostics and troubleshooting |
|
|
6 Diagnostics and troubleshooting
6.1Troubleshooting
Problem | Cause | Troubleshooting | |
|
|
| |
Sensor overtraveled | Sensor | Adjust or replace sensors, see page 61 | |
|
|
| |
| Controller | Check controller | |
|
|
| |
Motor load increases, controller | Guides and/or ball screw drive under | Contact service | |
switches off because of overload. | mechanical tension or excessive friction |
| |
| caused by poor lubrication. |
| |
|
|
| |
Noise and vibrations at high | Speed of rotation of ball screw too high | Reduce speed of rotation of ball screw | |
speed of rotation of the ball screw |
|
| |
Poor lubrication (in the case of noise) | Lubricate, see page 83 | ||
|
|
| |
| The ball screw must be replaced. Contact | ||
| shock | service | |
|
|
| |
Running inaccuracy and noise of | Poor lubrication | Lubricate, see page 83 | |
the guides |
|
| |
Damage to the guides, for example by | Replace guides, contact service | ||
| |||
| shock or impact on the carriage |
| |
|
|
| |
Carriage has backlash and posi- | Backlash in ball screw drive or guides | Contact service | |
tions inaccurately | after a collision or poor lubrication |
| |
|
|
|
MNA1MLSDM00EN, V2.01, 07.2009
Portal axes with ball screw drive | 59 |
