PAS4•S | 6 Diagnostics and troubleshooting |
|
|
Prerequisites |
Procedure |
2 |
1 |
Clamping plate |
| PAS41 | PAS42 | PAS43 | PAS44 |
|
|
|
|
|
|
Set screw DIN 913 - 45H |
| M3 x 10 | M4 x 10 | M5 x 16 | M6 x 20 |
|
|
|
|
|
|
Wrench size | [mm] | 2.5 | 3 | 4 | 5 |
|
|
|
|
|
|
Tightening torque | [Nm] | 0.2 | 0.3 | 0.4 | 0.5 |
|
|
|
|
|
|
Table 6.2 Tightening torques clamping plate
See chapter 7 "Accessories and spare parts" for suitable spare parts.
You need a set of Allen keys and a torque wrench with hexagon socket and a pair of tin snips.
Carry out the following steps on both ends of the carriage / linear axis.
2 set screws at the cover strip clamp fixate the clamping plate below and the cover strip.
Loosen the two set screws.
Remove the cover strip clamp (1). To do so, loosen the two screws. Keep the screws and the clamping plate (2) from falling down.
Remove the rubber buffer at the strip deflection. To do so, loosen the two screws.
MNA1MLSDM00EN, V2.01, 07.2009
Remove the holding plate together with the strip deflection. To do so, loosen the two screws.
Pull out the entire cover strip.
Remove the plastic unit from the housing of the strip deflection.
Insert the new plastic unit into the housing of the strip deflection.
Portal axes with ball screw drive | 65 |
