PAS4S

9 Glossary

 

 

MNA1MLSDM00EN, V2.01, 07.2009

9 Glossary

9.1Terms and Abbreviations

Axis body The axis body is a high-strength, torsion-resistant aluminum precision profile.

Ball screw drive The ball screw drive converts a rotary movement into a linear move- ment. It consists of a ball screw, a ball nut with the ball recirculating el- ements and the bearing balls. A ball screw drive has a very high efficiency. It allows for high-precision, stiff feed movements and gener- ates high feed forces at high positioning accuracy and repeatability.

Ball screw pitch The pitch of the ball screw shaft relates to the distance covered by the carriage per revolution of the ball screw. The greater the pitch the higher the maximum velocity.

The following applies to the ball screw pitch:

High pitch requires high driving torque

High pitch results in high velocity

High pitch causes high inaccuracy

High pitch implies little self-locking

Breakaway torque The breakaway torque describes the driving torque required to over- come the static friction and that initiates the transition to sliding friction.

Buckling load Buckling is the loss of stability of the spindles when the max. permissible feed forces whose line of application is along the spindle axis are ex- ceeded. Exceeding the buckling load is expressed by a quickly increas- ing change in the shape of the spindle with a deviation to the side.

Cantilever axis In the case of a cantilever axis, the carriage is stationary while the axis

body moves. Portal axes work the other way round.

Critical speed of the ball screw If the critical speed of the ball screw is exceeded, deflection of the ball screw and resonance will occur. This will seriously affect the service life of the ball screw drive. Ball screw supports are installed in longer ball screw axes to increase the critical screw speed and thus the perform- ance data.

Drive element The drive element of the linear axis is a ball screw drive.

Feed per revolution The feed per revolution is the distance the carriage covers per motor rev- olution.

Linear guide The linear guide consists of the guide carriage and the profile rail.

Load torque The permissible load torques are calculated based on the service life of the carriage guide. If the load torque exceeds the specified values, the service life of the axis will be reduced.

Modulus of elasticity The modulus of elasticity is used to describe the tendency of a material to deform along an axis when opposing forces are applied along this axis; it is the ratio of tensile strain and tensile stress. The higher the value, the stiffer the material.

Mounting position The linear axes can be installed in any desired position. However, all ex- ternal forces and torques must be within the ranges of permissible val- ues.

Portal axes with ball screw drive

87

Page 87
Image 87
Schneider Electric PAS4S manual Glossary, Terms and Abbreviations