6 Diagnostics and troubleshooting | PAS4•S |
|
|
Cut the new cover strip to the same length as the old cover strip with the tin snips.
Guide the new cover strip through the guide channel inside the car-
riage.
Guide the new cover strip through the strip deflections.
Place the holding plate for mounting the rubber buffer into position at the strip deflection.
Screw the strip deflection into place.
When doing so, align the strip deflection and the carriage.
Place the cover strip over the entire length of the axis body.
Align the cover strip symmetrically so that the distance to the two end blocks amounts to 1 ... 2 mm.
Verify that the cover strip has even contact with the magnetic strips.
2 |
1 |
Fit the clamping plate (2) into place.
Screw the cover strip clamp (1) into place with the tightening torque specified in Table 6.1.
MNA1MLSDM00EN, V2.01, 07.2009
66 | Portal axes with ball screw drive |
